![]() The database contains the following files: index- *. home flag sets both config and database locations at the same time. The location of the database can be changed using the -data flag. Use the old default location (same as config). If ~/.local/share/syncthing exists, use that location. If $XDG_DATA_HOME is set, use $XDG_DATA_HOME/syncthing. If a database exists in the old default location, that location is The database is stored either in the same directory as the config (usually theĭefault), but may also be located in one of the following directories (Unix-like csrftokens.txtĪ list of recently issued CSRF tokens (for protection against browser cross With a custom certificate for HTTPS as desired. The certificate and key for HTTPS GUI connections. The device’s ECDSA public and private key. In this directory the following files are (Unix-like), $HOME/Library/Application Support/Syncthing (Mac), The config location defaults to $HOME/.config/syncthing Syncthing also has a database, which is often stored in this directory too. Syncthing uses a single directory to store configuration and crypto keys. Previously the database wasĪlways located in the same directory as the config. This option could be necessary if Syncthing fails and/or the user configuration is broken.New in version 1.5.0: Database and config can now be set separately. As a result, the devices and folders are permanently removed from the server. Open interface allows user to access the Syncthing admin interfaceįactory reset allows the user to completely reset the Syncthing server configuration. Additionally, the user can remove a device/folder from synchronization by clicking on the drop-down menu ⋮ on the right side of the corresponding device/folder name.įrom the Syncthing Server panel, at the right top of the page, several options are available by clicking on the drop-down menu on the right. The same page can be accessed at this URL.įrom this page new devices and folders can be added by clicking on the buttons Which opens the management synchronization page, similar to the figure below. Users can have an overview of devices, servers and folders involved in the synchronization process by clicking on the button When adding a new folder on UCloud to sync, it can take few mins before asking confirmation locally and start the syncronization process. Likewise, previously added folders can be removed from synchronization by selecting the option Remove from sync. ![]() Once the Syncthing server is up and running, the user can add new folders any time by right-clicking on the folder name and selecting the option Add to sync. Which became visible at the top right of the same page. ![]() The drive can be removed afterwards, by clicking on the button The full content of a drive can be added for synchronization by clicking on the button This folder contains Syncthing configuration files. The user will then be guided through the necessary configuration steps, which include:Īdding the device identification to the serverĪfter completing the setup, a folder named Syncthing is created in the user's Home drive. This button is only available when Syncthing is not yet configured. To initially configure the UCloud Syncthing server, the user must enter a drive and click on the button This functionality is only available to the DeiC interactive HPC (SDU) provider. ![]()
0 Comments
Leave a Reply. |